(You save $3.51)

Breakout board for the Digitrax PM42 board

  • Plug in and screw terminal connections - EZ Wiring!
  • The PM42 breakout board is setup to accept up to 2 inputs and 4 distinct outputs.
  • Each output uses a set of jumpers that allows you to set that particular section to reversing, assuming the correct OpSwitches have been set inside the PM42's memory.
  • The board comes with one set, additional sets are available for $1.20 each by contacting us.
  • Most users only use one output, therefore no additional jumpers would be needed. This change went into effect 12/1/2015 by the manufacturer.
Current Stock:
Shipping Cost:
Calculated at Checkout

No Reviews Write a Review